Action mode: pilot type
Diameter range: DN0.1-600mm
Working environment temperature: -30—+80℃;-50—+100℃
Coil operating temperature: <+50℃, <+85℃
Control mode: Normally open, Normally closed
International standard voltage: AC (380, 220, 110, 24) V, DC (220, 110, 24, 12) V
Circulating fluid medium: steam, saturated steam and other high-temperature gases
Circulating fluid temperature: <+120℃, <+200℃, <+350℃
Circulating fluid pressure: 6bar, 16bar, 25bar, 40bar, 64bar
Valve body material: stainless steel (304, 316, 316L), cast steel
Connection method: threaded (internal thread, external thread) flange, welding, clamp, union
Leakage: zero leakage
If the fluid contains impurities, a filter valve (30-80 mesh/inch) must be installed at the inlet end of the solenoid valve, and there must be no solidification or crystallization.
2. There is no restriction on the installation position of the solenoid valve. (S-horizontal installation, C-vertical installation)
3. The above parameters are selected according to the requirements of the working conditions.
Action mode: pilot type
Diameter range: DN0.1-600mm
Working environment temperature: -30—+80℃;-50—+100℃
Coil operating temperature: <+50℃, <+85℃
Control mode: Normally open, Normally closed
International standard voltage: AC (380, 220, 110, 24) V, DC (220, 110, 24, 12) V
Circulating fluid medium: steam, saturated steam and other high-temperature gases
Circulating fluid temperature: <+120℃, <+200℃, <+350℃
Circulating fluid pressure: 6bar, 16bar, 25bar, 40bar, 64bar
Valve body material: stainless steel (304, 316, 316L), cast steel
Connection method: threaded (internal thread, external thread) flange, welding, clamp, union
Leakage: zero leakage
If the fluid contains impurities, a filter valve (30-80 mesh/inch) must be installed at the inlet end of the solenoid valve, and there must be no solidification or crystallization.
2. There is no restriction on the installation position of the solenoid valve. (S-horizontal installation, C-vertical installation)
3. The above parameters are selected according to the requirements of the working conditions.