Action mode: pilot type
Diameter range: DN1-600mm
Working environment temperature: -30—+80℃;-50—+100℃
Coil operating temperature: <+50℃, <+85℃
Control mode: normally open, normally closed, with manual control
International standard voltage: AC (380, 220, 110, 24) V, DC (220, 110, 24, 12) V
Circulating fluid medium: water, gas, oil, flammable, explosive, corrosive, high and low temperature fluids
Circulating fluid temperature: <-100℃, <-40℃, <+60℃, <+120℃, <+200℃, <+350℃
Circulating fluid pressure: 6bar, 16bar, 25bar, 40bar, 64bar
Valve body material: stainless steel (304, 316, 316L), cast steel
Connection method: threaded (internal thread, external thread) flange, welding, clamp, union
Leakage: zero leakage
1. If the fluid contains impurities, a filter valve (30-80 mesh/inch) must be installed at the inlet end of the solenoid valve, and there should be no solidification or crystallization.
2. There is no restriction on the installation position of the solenoid valve. (S-horizontal installation, C-vertical installation)
3. The above parameters are selected according to the requirements of the working conditions.
Performance features: piston structure, manual wheel, both automatic and manual control, sensitive opening and closing, safe and reliable
Application scope: water supply and drainage, fire protection equipment, building automation, power equipment, etc.
Action mode: pilot type
Diameter range: DN1-600mm
Working environment temperature: -30—+80℃;-50—+100℃
Coil operating temperature: <+50℃, <+85℃
Control mode: normally open, normally closed, with manual control
International standard voltage: AC (380, 220, 110, 24) V, DC (220, 110, 24, 12) V
Circulating fluid medium: water, gas, oil, flammable, explosive, corrosive, high and low temperature fluids
Circulating fluid temperature: <-100℃, <-40℃, <+60℃, <+120℃, <+200℃, <+350℃
Circulating fluid pressure: 6bar, 16bar, 25bar, 40bar, 64bar
Valve body material: stainless steel (304, 316, 316L), cast steel
Connection method: threaded (internal thread, external thread) flange, welding, clamp, union
Leakage: zero leakage
1. If the fluid contains impurities, a filter valve (30-80 mesh/inch) must be installed at the inlet end of the solenoid valve, and there should be no solidification or crystallization.
2. There is no restriction on the installation position of the solenoid valve. (S-horizontal installation, C-vertical installation)
3. The above parameters are selected according to the requirements of the working conditions.
Performance features: piston structure, manual wheel, both automatic and manual control, sensitive opening and closing, safe and reliable
Application scope: water supply and drainage, fire protection equipment, building automation, power equipment, etc.