Quick Air Vent (inlet) Valve (KP-1.0 Type (P2X))

summary

This product is used at the highest point of the pipe or where the gas is closed and at the pump outlet

Remove the gas in the pipe to dredge the pipe, to achieve the normal operation. If no exhaust valve, pipe

Air resistance appears at any time, so that the effluent capacity of the pipeline can not meet the design requirements. Secondly: pipeline

During operation, power failure and timely negative pressure of pump stop pipeline will cause pipe vibration or breaking

Crack, exhaust, suction valve will quickly put the air into the pipe, to prevent the pipe vibration or rupture.

action principle

When the water enters the pipe, the float ball stops at the bottom of the barrel for a large amount of exhaust, when the exhaust

At completion, the water into the valve through the ball ball guide closed, stop in the exhaust, the pipe in

During normal operation, a small amount of gas will naturally be produced, which will be concentrated in the upper part of the pipe

To a considerable extent, the water level in the valve drops, the floating ball drops smoothly and the gas flows from the hole. As out

Now the power is cut off the pump, when the water in the pipe is empty, negative pressure will appear at any time, the floating ball drops smoothly,

Open the hole to drive the open, a large amount of gas supply to ensure the safety of the pipeline.

Note: The pressure of the exhaust valve should not be lower than 0.02MPa during use, if it is lower than 0.02MPa,

The exhaust valve is prone to water leakage, and the valve must be equipped with a valve for maintenance.

technical parameter

External Dimension Table